Timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02 Hi, My tunnel just got hung and unable to send traffic on the ASA.
Mode Config, EasyVPN, DHCP over VPN) you may be able to assign a local address to VPN Tracker that is. Nat (DMZ,Outside) static interface service tcp ftp ftpĪccess-group DMZ_access_in in interface DMZĪccess-group Outside_access_in in interface Outside If you are using an automatic configuration method (e.g. Nat (DMZ,Outside) static interface service tcp www www Nat (inside,Outside) source static InsideNetwork InsideNetwork destination static InsideNetwork InsideNetwork The Cisco Easy VPN client Here are the steps: enable IPv6 routing on a Cisco router using the ipv6 unicast-routing global configuration command The script. Icmp unreachable rate-limit 1 burst-size 1 Site 1 cannot ping the inside interface of site 2, however site 2 can ping the inside interface of site 1. I've compared the configs of our offices and they do not look any different, so I do not know what I'm missing. Ip local pool VPNpool 10.0.10.100-10.0.10.200 mask 255.255.255.0 I cannot ping one of our remote offices ASA 5505's across the site-to-site VPN tunnel. Service-object tcp destination eq ftp-dataĪccess-list inside_access_in extended permit icmp any anyĪccess-list Outside_access_in extended permit object-group DMZservices object TrustedUsers host 10.0.20.2Īccess-list Outside_access_in extended permit tcp object UntrustedUsers host 10.0.20.2 eq 255.255.255.0Īccess-list DMZ_access_in extended permit icmp any any object-group ICMPALLĪccess-list global_access extended permit icmp any any object-group ICMPALL Same-security-traffic permit intra-interface Just in case i tried allow all traffic rules but did not help. Moreover Inside->DMZ etc do not suppose to require any Nat or access rules to work. When i had a similar issue it was Nat issues.ĭocumentation and blogs are saying about how the Asa is using Xlate(Nat) rules to route traffic first prior to routing table and thus the failed to locate egress interface(cannot route traffic) if Nat fails. Packet tracer in ASDM indicates access rule but i cannot see(click on the rule), and i cannot create a reverse rule from Packet tracer. I cant ping from Inside->Outside ,DMZ->Outside ,Inside->DMZ
0 kommentar(er)
